This message means that the value of a module, loop, PCU, block or specification was larger than the allowed value. In the case of the module out of range, it usually means that S2 is the intended value for the module and S1 is the intended block value. In the other cases, it is likely that a spec has been entered incorrectly in some way.
--Scanning drawing 2500451 Module 8713 out of range for Module 2,50,04 Block 1699 (FC 121). Module 8605 out of range for Module 2,50,04 Block 1698 (FC 121).
This error can be built directly into Hyperview. For more information, see the article Building error reports into the M14.