DBDOC TSTALM.ERR

This message tells you that the same block is being tested more than once. This nearly always means that a TSTALM block was cloned, its output block changed, but the value of S1 left untouched.

This message shows two problems:

• Action that is desired will not happen, because the status of the intended block is not being tested.
• Action might be taken based on the status of the wrong block.

--Module 6,70,03 TSTALM Report
Module 6,70,03 Block 1529 is tested by multiple TSTALM blocks (mode 2).

This error can be built directly into Hyperview. For more information, see the article Building error reports into the M14.